Iron, Steel and Ferrous Structure

slide
slide
slide
slide
slide
slide
slide
slide
slide
Prev
Next


SURFACE PREPRATION

It is essential that before painting, the surfaces should be cleaned as far as possible to bright metal. The ideal surface preparation would be sandblasting but this is not always possible and as such the alternate would be chipping and wire-brushing to remove all scales, rust etc. immediately after surface preparation apply 1 coat of appropriate Wood Primer.

PRIMER COAT

Depending on the conditions of painting and the end use of the painted article, apply Rainbow Red Oxide Primer. 1 to 2 coats with intervals of 16 hours between coats – is suggested.

FINISHING COAT

Apply 2 coats of Rainbow Super Gloss Enamel allowing 12 to 16 hours drying time between coats. It can be applied with brush, roller or spray. To obtain desired viscosity, thin up to 10% by using good-quality mineral turpentine (white spirit).

COVERGAE

Coverage will be depending on surface and application but on an average, 1 liter of Rainbow Super Gloss Enamel will cover 16 to 18 m2 per coat on a normal surface.

Gallery

Welcome to Rainbow Paint, your one stop paint store for all of your decorative needs. View Our Gallery

Visualizer

Welcome to Rainbow Paint, your one stop paint store for all of your decorative needs. View Our Visualizer

Color Calculator

Welcome to Rainbow Paint, your one stop paint store for all of your decorative needs. View Our Calculator